Daewoo DSA-100L Manual de usuario descargar pdf (Pagina 18)

page 18

Adjustment and coding

The power limits are now set.

Putting into operation

Switch on at the mains. LED lights up. After pressing the test buttons the gate at first

moves in the direction of the reference point.

(If the drive operator is not installed, the swivel joint (fig 1 "C" must be held in a vertical position).

Important: The limit stop is pre-set at the factory.

The power limit can now be set in accordance with fig. 9c.

Proceed with programming the remote control as illustrated in fig. 9d.

Press the button to bring the gate into the final "open" position, then proceed with programming

the final positions in accordance with fig. 9e.

The programming procedure terminates automatically 30 seconds after the last entry, or can be

terminated manually by pressing the "P" button (see figs. 9d, 9e, 9f, 9g, 9h, 9i and 9n).

P Coding button

Power setting "open"

Power setting "close

Test button "open"

Test button "close"

Final "open" position

Final "close" position

Remote control

Operation/Coding

Error message

Setting the power limits

Press the button to set the power limit "open", and press the button to set the power limit "close".

The set value will be indicator.

By repeatedly pressing the appropriate button, the power limit can be set in stages from 0

(most sensitive value) to 19 (pre-set value = 9).

Attention: To protect persons as well as the mechanical parts of the door and operator, set the power limit as

sensitively as possible - on no account exeed 150 N (approx. 15 kg.)

"OPEN" direction "CLOSE" direction

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Sin comentarios

Daewoo DSA-100L Manual de usuario Pagina 18